Compaq ProLiant Storage System U1 Guia do Utilizador descarregar pdf (Página 87)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

5-11 Option Installation

Compaq ProLiant Storage System /U User Guide

Rack system:

a. Loosen the two thumbscrews securing the system in the rack.

b. Remove the 8 screws marked with a

securing the front panel

to the chassis. The chassis will slide free from the rack.

c. Carefully slide the drive cage out of the chassis. The removal of the

drive cage is best performed outside of the rack .

TROJ029.EPS

Figure 5-7.

Removing the drive cage from the rack system

6. Select and install the correct front panel.

7. Carefully slide the Dual Bus drive cage into the chassis as far as it will

go. The drive cage is properly seated when the front panel is flush with

the front of the chassis and the screw holes are aligned.

IMPORTANT:

There are two alignment pins on the back and two capture

fingers on the side (bottom in rack units) of the drive cage which must engage

corresponding features on the chassis. It may be necessary to “wiggle” the drive

cage slightly in order to properly seat it in the chassis. The units will mate

easily when properly aligned. Do not force the two units together if there is

obvious resistance.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 109 110

Sem comentários

Compaq ProLiant Storage System U1 Guia do Utilizador Página 87