Compaq ProLiant Storage System U1 Guia do Utilizador descarregar pdf (Página 47)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2-19 Installation of ProLiant Storage System /U

Compaq ProLiant Storage System /U User Guide

6. Locate the SCSI controllers and verify that the installed drives

are displayed.

7. If you are using a Compaq SMART SCSI Array Controller or a

SMART-2 Array Controller Family Product, you should verify the

logical drive configuration, paying special attention to the selected fault

tolerance method. For this configuration information, refer to:

❏ the README files for Release Notes for Compaq supplied

operating systems

❏ your software documentation for other operating systems

❏ the documentation supplied with your Compaq array controller

8. Select Save the configuration and exit.

The utility will configure your system to recognize any new controllers and

devices. Reboot your system normally to begin using the added disk space on

the storage system.

From Diskette

Use these instructions to run the Compaq System Configuration Utility if

your server:

■ has not had this utility previously installed on the boot drive, and

■ does not have a bootable CD-ROM drive

To create and use System Configuration Utility diskettes from the SmartStart

and Support Software CD included with the ProLiant Storage System /U:

1. Insert the SmartStart and Support Software CD with the

system running.

2. Run the \DSKBLDR\DSKBLDR.EXE file from a Windows 95 or

Windows NT system. In some systems, the Diskette Builder utility will

start automatically.

3. Select Create software diskettes from CD only.

4. Select (check) Compaq System Configuration Utility.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 109 110

Sem comentários

Compaq ProLiant Storage System U1 Guia do Utilizador Página 47