Compaq 3100ES - Smart Array RAID Controller Guia do Utilizador descarregar pdf (Página 144)

Compaq Smart Array 431 Controller User Guide

continued

1789 Slot x Drive Array SCSI Drive(s) Not

Responding. Check cables or replace the

following SCSI drives: SCSI Port (y):

SCSI ID (x)

Select to continue - drive array will

remain disabled.

Select to failed drives that are not

responding - Interim Recovery Mode will be

enabled if configured for fault tolerance.

This message indicates that previously

operating drives are missing or inoperative

following a cold or warm reset. Turn off system

and check cable connections. If cables are

connected, replace the drive. Press to restart

the computer with the drive array disabled.

-Or-

If you do not want to replace the drives now,

press .

: Message 1788 might also be displayed inadvertently due to a bad power cable connection to the

drive or a defective SCSI cable. If this message was due to a bad power cable connection, repair the

connection and press . If this message is not eliminated by pressing , run the Drive Array Advanced

Diagnostics Utility.

-OR-

If this message was not due to a bad power cable connection, and the drive was not replaced, this could

indicate a defective SCSI cable. Contact your Authorized Compaq Service Provider.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 161 162

Sem comentários

Compaq 3100ES - Smart Array RAID Controller Guia do Utilizador Página 144