Compaq DS10 Instruções de Operação descarregar pdf (Página 152)

3-40 DS10 / DS10L Console Reference

3.14.18 set escape

The set escape command changes the escape sequence used for

invoking the RMC.

The escape sequence can be any character string, not to exceed 14 characters. A

typical sequence consists of two or more control characters. It is recommended

that control characters be used in preference to ASCII characters. Use the

status command to verify the escape sequence.

Be sure to record the new escape sequence. If you forget the escape sequence,

you must reset the RMC to the factory defaults. See Section 3.12 for

information on setting the RMC to the factory defaults.

The following example consists of two instances of the Esc key and the letters

“FUN.” The “F” is not displayed when you set the sequence because it is

preceded by the escape character. Enter the status command to see the new

escape sequence.

Syntax: set escape

Example:

RMC> set escape

Escape Sequence: un

RMC> status

Escape Sequence: ^[^[FUN

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 181 182

Sem comentários

Compaq DS10 Instruções de Operação Página 152