Compaq DS10 Instruções de Operação descarregar pdf (Página 140)

3-28 DS10 / DS10L Console Reference

3.14.1 clear alert

The clear alert command clears the current alert condition and

causes the RMC to stop paging the system operator at the

remote location.

If the alert is not cleared, the RMC continues to page the remote operator every

30 minutes if both remote access and alerts are enabled.

The clear alert command clears the current alert so that the RMC can capture

a new alert. The last alert is stored until a new event overwrites it. The Alert

Pending field of the status command becomes NO after the alert is cleared.

Syntax: clear alert

3.14.2 clear port

The clear port command uses the console port modem control

signals to clear any “stuck” conditions on the system’s COM1

port.

The clear port command attempts to free the port by resetting all UARTs

controlled by the RMC if the port is currently locked by an application program,

without resetting the entire system.

Syntax: clear port

NOTE: This command also causes the modem to disconnect.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 181 182

Sem comentários

Compaq DS10 Instruções de Operação Página 140