Compaq System/E25 Instruções de Operação descarregar pdf (Página 3)

In This Guide

This guide shows how to install the HP SureStore Virtual Array 7100 deskside, field-rackable, and factory-

racked products.

Summary of Installation Steps:

Follow the installation steps in the table below. Check them off as they are completed. (Some steps may not be

necessary for your configuration.)

*The installation steps in this guide show only field- and factory-racked arrays for simplicity. The deskside array

differs from the racked array mainly in its orientation (see Fig. 1 through Fig. 4). Refer to these figures when locating

corresponding parts on a deskside array.

✔

Section Installation Step*

A Unpack the array.

Is your array a field-rackable product?

If YES, install the array into a rack. If NO, go to

Section C.

C Connect the power cables and host fibre channel cables to the array.

Do you need to change the array host port behavior (Section F) or the array loop IDs

(Section G)?

If YES, connect the serial cable to the array RS-232 port and to an RS-232

terminal, and start a terminal emulator. If NO, go to Section E then go to Section H.

E Power-on the array and verify that it passes self-test.

Is the array connected to a host running Windows 2000, Windows NT, or Linux?

If YES,

change the array host port behavior. If NO (host running HP-UX), go to Section G.

Are any other devices using loop ID 108 or 110?

If YES, change the array loop IDs. If

NO, go to Section H.

H Install the array software. Refer to the

HP Command View SDM User’s Guide

Fig. 1. Deskside Array - Front View Fig. 2. Deskside Array - Rear View

Fig. 3. Racked Array - Front View Fig. 4. Racked Array - Rear View

1 2 3 4 5 6 7 8 ... 23 24

Sem comentários

Compaq System/E25 Instruções de Operação Página 3