Compaq System/E25 Instruções de Operação descarregar pdf (Página 21)

19

E. Powering-On the Array

E. Powering-On the Array

1. Press in the power/standby switch

with the retracted tip of a pen or

pencil to power-on the array (see

Fig. 42). Allow 2 minutes for the

disk drives and controllers to

complete their self-tests.

NOTE: Disk drives are not visible on

the bus until they have completed

their self-tests.

2. Verify that the system activity LED

is ON and the disk drive activity

LEDs are ON (both green).

Fig. 42. Powering-on the array

NOTE: If a terminal emulator or RS-

232 terminal is connected to the RS-

232 port on either controller, the

virtual front panel will display the

initialization sequence during

power-on.

CAUTION! If any amber LEDs are

ON, or if you hear a series of beeps,

refer to the VA 7100 User’s Guide, part

no. A6183-90900, to begin trouble-

shooting steps.

System Activity LED (Green)

Disk Fault LED (Amber)

Disk Activity LED (Green)

System Fault LED (Amber)

1 2 ... 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários