Compaq External RAID Controller & Subsystem Manual do Utilizador descarregar pdf (Página 187)

Advanced Configurations

9-2

9.1.1 Clone Failing Drive:

Unlike the similar functions combined with S.M.A.R.T., the “Clone

Failing Drive” is a manual function. There are two options for

cloning a failing drive: “Replace after Clone” and “Perpetual

Clone.”

Replace after Clone:

Data on the source drive, the drive with predicted error (or any

selected member drive), will be cloned to a standby spare and

replaced later by the spare. The status of the replaced drive, the

original member drive with predicted error, will be redefined as an

“used drive.” System administrators may replace the used drive

with a new one, and then configure the new drive as a spare drive.

Locate the logical drive to which the specific member drive with

predictable errors belongs. Select the “clone failing drive” function.

Select “Replace After Clone.” The controller will automatically start

the cloning process using the existing “stand-by” (dedicated/global

spare drive) to clone the source drive (the target member drive with

predicted errors). If there is no standby drive (local/global spare

drive), you need to add a new drive and configure it as a standby

drive.

The cloning process will begin with a notification message. Press

[ESC] to proceed.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 346 347

Sem comentários

Compaq External RAID Controller & Subsystem Manual do Utilizador Página 187