Compaq ELSA GLoria Synergy Guia de Instalação

Compaq Computer Corporation ELSA GLoria Synergy Graphics Controller Installation Guide Order Number: EK-COMGS-IG. C01 This guide describes the i

1-4 ELSA GLoria Synergy Graphics Controller Installation Guide 1.3 Connector Pinouts Table 1–3 contains a listing of the pins and signals found

Overview 1-5 1.4 Specifications Table 1–4 lists the specifications for the ELSA GLoria Synergy graphics controller. Table 1– 4 ELSA GLoria Syner

Installation 2-1 Chapter 2 Installation 2.1 Introduction This chapter describes the installation of the ELSA GLoria Synergy graphics controller in

2-2 ELSA GLoria Synergy Graphics Controller Installation Guide 2.3 Installation Procedure (Windows NT 4.0) ___________________________Note ______

Installation 2-3 5. From the Display Properties dialog box, choose the Settings tab. 6. From the Settings dialog box, choose the Display Type but

2-4 ELSA GLoria Synergy Graphics Controller Installation Guide 18. After installing the ELSA GLoria Synergy graphics controller, reboot your syste

Installation 2-5 ___________________________Note ____________________________ Before installing the graphics controller, check your monitor specif

Compaq Tru64 UNIX Configuration 3-1 Chapter 3 Compaq Tru64 UNIX Configuration The following two configurations are supported by both Compaq Tru64 U

© 2000 Compaq Computer Corporation Compaq, the Compaq logo, Compaq Insight Manager, AlphaServer, StorageWorks, and TruCluster Registered in U.S. Paten

3-2 ELSA GLoria Graphics Controller Installation Guide 3.2 Configuring Graphics Resolution or Vertical Refresh Rate There are two X server related

Compaq Tru64 UNIX Configuration 3-3 2. Make a backup copy of the file /usr/lib/X11/xdm/Xservers . Example: # cp /usr/lib/X11/xdm/Xservers /usr/l

3-4 ELSA GLoria Graphics Controller Installation Guide 4. Restart the GUI. # /sbin/init.d/xlogin stop # /sbin/init.d/xlogin start Examples of

Compaq Tru64 UNIX Configuration 3-5 ___________________________Note ____________________________ • These are device dependent X server options an

3-6 ELSA GLoria Graphics Controller Installation Guide boards. The other boards must have their VGA jumpers set to "disable." See your w

Compaq OpenVMS Configuration 4-1 Chapter 4 Compaq OpenVMS Configuration This chapter provides information for installing and modifying the ELSA GLo

4-2 ELSA GLoria Graphics Controller Installation Guide Table 4–1 OpenVMS Versions Supporting the ELSA GLoria Synergy Graphics Controller OpenVMS V

Compaq OpenVMS Configuration 4-3 determine if the UPDATE kit has superseded the GRAPHICS kit or if the GRAPHICS kit is newer than the UPDATE kit.

4-4 ELSA GLoria Graphics Controller Installation Guide 4.4 Default Settings The default graphics resolution is 1024 x 768. The default refresh rat

Compaq OpenVMS Configuration 4-5 Additional system logicals are described in SYS$MANAGER:DECW$DEVICE_CONFIG_GZ.COM. However, this file should not b

iii Contents Preface...v Cha

4-6 ELSA GLoria Graphics Controller Installation Guide 4.7.1 Matching Primary Screen with VGA Console Screen 0 is always the VGA-enabled head and

iv 4.2.1 OpenVMS Version 7.3... 4-2 4.2.2 OpenVMS Version 7.2-1H1, 7.2-1, and 7.1-

v Preface Intended Audience This manual is for owners installing the ELSA Gloria Synergy graphics controller in a computer system. Document Structure

vi Conventions Used in This Guide In this guide, every use of Windows NT means the Windows NT operating system. This guide also uses the following con

Overview 1-1 Chapter 1 Overview 1.1 Introduction This chapter provides a brief overview of the ELSA GLoria Synergy and PowerStorm 4D10T graphics c

1-2 ELSA GLoria Synergy Graphics Controller Installation Guide Table 1–2 provides a support matrix for the SN-PBXGK-BB and SN-PBXGK-BC ELSA GLoria

Overview 1-3 Figure 1– 1 ELSA GLoria Synergy Graphics Controller 21ML014687 Standard 15-pin VGA connector VGA enable/disable switch (switch de