Compaq 380 Especificações descarregar pdf (Página 43)

Removal and Replacement Procedures 2-31

SCSI Backplane

To remove the SCSI backplane:

1. Power down the server. See the “Powering Down the Server” section in this chapter.

2. Extend or remove the server from the rack. See the “Preparation Procedures” section in

this chapter.

3. Remove the access panel. See the “Access Panel” section in this chapter.

4. Remove any hot-plug SCSI hard drives. See the “Hot-Plug SCSI Hard Drive” section in

this chapter.

5. Remove the tape drive, if installed. See the “Universal Hot-Plug Tape Drive” section in

this chapter.

6. Remove all hot-plug fans from the front fan bracket. See the “Hot-Plug Fan” section in

this chapter.

7. Remove the front fan bracket. See the “Front Fan Bracket” section in this chapter.

8. Disconnect any cables connected to the SCSI backplane.

9. Loosen the two SCSI backplane thumbscrews .

10. Lift the SCSI backplane .

Figure 2-30. Removing the SCSI backplane

Reverse steps 1 through 10 to replace the SCSI backplane.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 120 121

Sem comentários

Compaq 380 Especificações Página 43