Compaq TL891 - DLT Tape Library Guia do Utilizador descarregar pdf (Página 85)

DLT MiniLibrary (TL891) - User’s Guide

B-4 EK-TL891-UG. A01

B.1.1 Rackmounting in a Standard (19”) EIA/RETMA Cabinet:

These procedures assume that you have already separated the slide racks and attached

the mounting brackets to the slides as described in the beginning of this chapter. Next:

1. Fasten each outer slide behind the front rail of the rack using two 10-32

low-

profile

screws with washers and one nut plate. Two 10-32 clip nuts are

provided to engage the captive screws on the front panel.

2. Fasten each of the mounting brackets to the front of the rear rail of the rack

using two 10-32 screws and one nut plate.

3. Tighten the screws installed in step 4.

4. If they are not already locked, pull the intermediate slides toward the front

(out of the rack) so that they lock in the extended position.

Figure B-2 Rack Slide Parts for Standard 19” EIA/RETMA Rackmounting

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 112 113

Sem comentários

Compaq TL891 - DLT Tape Library Guia do Utilizador Página 85