Compaq ProLiant ML350p Guia de Instalação descarregar pdf (Página 31)

Overview of Server Installation 2-7

For use with 1-GHz or greater Intel Pentium III processor-based server models only

Compaq Confidential – Need to Know Required

Writer: Doug Warren Project: Compaq ProLiant ML350 Setup and Installation Guide Comments:

Part Number: 201345-001 File Name: c-ch2 Overview of Server Installation.doc Last Saved On: 7/11/00 9:03 AM

Operating System Purchased Separately

If you purchased your operating system separately, install it using the

SmartStart and Support Software CD. Refer to the Server Setup and

Management pack for instructions on using SmartStart. The first time the

server is configured, the SmartStart program automatically creates a necessary

partition on your hard drive. This partition cannot be used for any other

purpose and is not a traditional system partition.

The following sequence should be performed when setting up your server for

the first time:

IMPORTANT: To reduce the risk of damage to your server, complete the installation

process by following the detailed procedures provided later in this chapter and in other

sections of the setup and installation guide.

1. Select a site and unpack the server, keyboard, and mouse. See

“Preinstallation Procedures” earlier in this chapter.

2. Install any PCI expansion boards if needed. See Chapter 3, “Hardware

Options Installation,” or see the options kits for detailed installation

instructions.

3. Install any other options: additional memory, hard drives, and external

storage devices. See Chapter 3, “Hardware Options Installation,” or see

the options kits for detailed installation instructions.

IMPORTANT: After installing options, you need to run the ROM Based Setup Utility (RBSU)

to change the boot device after completing this setup process. See Chapter 5, “Server

Configuration and Utilities,” for more on running RBSU.

4. Connect cables: keyboard, mouse, monitor, network, and power. See

“Preinstallation Procedures” earlier in this chapter.

5. Set switches: system board switches, Server Feature Board switches,

and SCSI ID settings. If changes are required, see Chapter 3, “Hardware

Options Installation.”

6. Locate the key and unlock the front bezel if necessary.

NOTE: A key hook is located inside the front bezel above the keylock latch. For your

convenience, you may use the key hook to store the key when it is not needed.

7. Power up your server by pressing the power button on the front of the

server.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 117 118

Sem comentários

Compaq ProLiant ML350p Guia de Instalação Página 31