Compaq MC-1 Manual do Utilizador descarregar pdf (Página 80)

Messages and Diagnostic Codes

Page 72 34-ST-25-20 MC Toolkit User Manual Release 0

7/03

MC TOOLKIT ERROR MESSAGES

Memory Error If several programs are active, try closing one or more open

programs.

Too many programs installed in the Pocket PC. Check the Pocket

PC free memory. Uninstall programs if need to release memory.

Too many data files in the Pocket PC. Check the Pocket PC free

memory. Delete unused data files to release memory.

Use the Pocket PC hardware reset. See your Pocket PC

documentation reset the unit. Caution: If the Symbol PPT 2800

computer is reset, it will lose all its installed programs and data. The

program will have to be installed again.

Message length is longer than expected

Message length is shorter than expected

Communications problem between the Pocket PC computer and the

modem. Repeat the command again.

Modem bad checksum

This could indicate a defective modem. Repeat the command again.

If the problem persist contact Honeywell TAC.

Modem Buffer overflow

Modem busy

Modem framing error

Modem illegal command

Modem illegal data

Modem network error

Modem Transmitter Serial Error!

Communications problem between the Pocket PC computer and the

modem. Repeat the command again.

No Response from the Transmitter

Make sure that the MC Toolkit field connections are connected to the

transmitter.

Verify the transmitter is wired correctly and that it is powered.

If connected to a DE transmitter, make sure the polarity of the cables

connecting to the transmitter is correct.

If connected to a HART transmitter, make sure the address number is

correct.

Make sure the correct protocol for the transmitter is selected.

A defective transmitter can also cause this error message.

Verify that a 250 ohm resistor in series with the transmitter.

Resume Monitor Thread Failed! Close all the other running applications.

Restart MC Toolkit application.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 109 110

Sem comentários

Compaq MC-1 Manual do Utilizador Página 80