Compaq Compaq Portable II Guia de Resolução de Problemas descarregar pdf (Página 107)

To replace the power supply, reverse steps 1 through 14.

Chapter 8.20 Mass Storage Device Enclosure

To remove the mass storage device enclosure:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. Remove the interface connector cover, if installed (see Section 8.5).

4. Remove the 32 bit memory/modem interface board, if installed (see

Section 8.8).

5. Remove the system board (see Section 8.14).

6. Remove the mass storage device subassembly (see Section 8.16).

7. Place the computer in an upright position.

8. Place the plasma display at an outward angle, and remove the top two

screws and washers from the mass storage device enclosure with an angle

Torx screwdriver (Figure 8-56).

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 165 166

Sem comentários

Compaq Compaq Portable II Guia de Resolução de Problemas Página 107